Colour monitor with touchscreen<>Semi automatic setting<>Board magazin<>Centre strip infeed (stiff)<>Cloth feeder<>Glue unit<>Preheated glue tube<>Viscosity control<>Has an additional device for cutting in one pass for use on covers and spine<>Has the possibility of gluing a mirror in the second pass.<>Thickness 90 - 150 g/m2 (laminated)<>Thickness of the leatherette cover material: 0.1 - 0.3 mm<>cardboard slitter x 1<>equipment for the production of three-part (suspended) covers in two production runs x 1<>equipment for the production of one-part, suspended covers, allowing for gluing a mirror in the<>second production run x 1<>matrix carrier sheet x 10<>rubber blanket in a roll 10 meters x 600 mm wide x 1<>double-sided adhesive tape for gluing the matrix to the sheet x 2<>device for cutting corners x 1<>device for cutting to the leading edge of the rubber mat of the matrix x 1<>evice for stretching and trimming the rubber matrix on the carrier sheet x 1<>vacuum pump x 1<>set for off-line pre-cutting of cardboard type KRS-II 120 x 1<>set for cover refinement x 1<>Pressing station<>Counter approx 26 mio book covers<>Cardboard thickness<>• Minimum: 1.5 mm<>• Maximum: 4 mm<>• Possibility of using cardboard with foam with the following parameters:<>• Maximum cardboard 1.5 mm - foam 3 mm<>• Minimum cardboard 1.5 mm - foam 2 mm<>Book cover format range<>• Height: minimum 100 mm, maximum 390 mm<>• Width: minimum 170 mm, maximum 660 mm<>• Burning:<>9mm - bobbin spine - 2mm and 2.5mm cardboard<>10mm - bobbin spine - 3mm cardboard<>11mm - cardboard spine - 2mm and 2.5mm cardboard<>12mm - cardboard spine - 3mm cardboard